Which sequence outlines the steps to remove a recloser?

• A. Open the main switch; disconnect all wires; remove it
• B. De-energize all nearby circuits
• C. Replace with new recloser before taking old out
• D. Close bypass or install temp jumper; switch open; remove load side; remove source side; keep jumpers in the clear in case it didn't open internally.

Answer: (C)

Keeping protection in service while you swap equipment is the key idea. The best approach is to install a new recloser in place before taking the old one out. This ensures the circuit remains protected and the protection scheme continues to operate, minimizing outage time and avoiding a window where the line would be unprotected. It also allows you to verify the new unit’s function before removing the old device, all while following proper lockout/tagout procedures.

The other options don’t fit because they either leave the line temporarily unprotected, rely on a hazardous bypass arrangement, or omit the necessary step of having a ready replacement in place before removing the old unit.